Making the Front Tire

Creating the front tire

Created a torus to make the rubber part of the tire.

I selected two of the inner edges of the torus and used ring to be able to select all the inner edges and then used extrude twice. I scaled the extruded pieces so that they would not go past the edge of the tire and then applied NURMS.

Created a tube and aligned it roughly with the rim in the picture. Next I adjusted the pivot point of the rim using hieracy and had it center to the object and then aligned the rim to the spokes pivot point to pivot point. Then I aligned the wheel to the rim using pivot point to pivot point again.

Applied NURM to the rim and then used the swift loop to add some definition to the rim. I also grouped the spokes, the rim and the tire together.